Electrical
Panels, circuits, lighting, and code-compliant rough-ins coordinated with the rest of the build.
Overview
Electrical in Orlando & Central Florida
Electrical work is where corner-cutting becomes dangerous rather than merely ugly. Overloaded panels, missing GFCI and AFCI protection, and unpermitted circuits show up on inspection reports and in insurance claims.
STRUXA coordinates licensed electrical work as part of the overall build, so rough-ins land before drywall and lighting layouts are set before ceilings close.
Every circuit we install is permitted, inspected, and labeled at the panel — including the older Orlando homes where the existing service needs to be brought up to current load.
What’s Included
Scope You Can Hold Us To
- Panel replacement and service upgrades
- New branch circuits and dedicated appliance circuits
- Rough-in wiring for remodels, additions, and build-outs
- Recessed, under-cabinet, and exterior lighting
- Switches, dimmers, receptacles, and USB outlets
- GFCI and AFCI protection to current code
- Ceiling fan and fixture installation
- EV charger circuits and generator interlocks
- Permits, inspections, and panel labeling
How It Works
Four Steps, Electrical
- 01
Load Review
We check existing service capacity, panel condition, and what the new scope will demand.
- 02
Estimate
Written scope listing devices, circuits, fixtures, and permit fees separately.
- 03
Install
Rough-in, inspection, close-in, then trim-out with fixtures and devices set and tested.
- 04
Walkthrough
We test every device and breaker with you and hand over a labeled panel schedule.
Questions
Electrical FAQ
Something not covered here? Call (407) 444-1653 and ask directly — we answer scope questions before you commit to anything.
Nearly always. Panel changes, new circuits, and rough-ins are permitted and inspected. Like-for-like device swaps generally are not. We handle the permit under license when one is required.
Frequent breaker trips, no room for new circuits, scorching or rust inside the panel, or a known problem brand are all indicators. We open the panel and give you a straight assessment.
Yes. Retrofit LED cans install through small ceiling cuts, and we patch and texture-match any drywall we open. We lay out spacing before cutting so the light is even.
Yes. We verify panel capacity, run the dedicated 240V circuit, mount the unit, and pull the permit. Most residential installs finish in a single day when capacity already exists.
We can, though our value shows most when the electrical is coordinated with framing, drywall, and finishes so nothing gets opened twice.
Ready to Build?
Tell us about your electrical project and get a written, itemized estimate — no obligation.